2022-12-12
The PN300 plastic line disk is divided into 3 types: integrated, assembly large tube and assembly small tube.
1. Integrated
It is formed by the injection molding machine at one time, and the sticky cover is synthesized. The dynamic balance is good, the weight is 1.3kg, the plate has a lot of reinforcement, and it can bear 30kg normally. It is used for long -term turnover such as wires, core wires, and rope bands; due to the good dynamic balance, a small part is also used on the drawing machine (the rubber plate weight is light, the integrated dynamic balance is good, and there will be no big swing, but the life span will be reduced. a lot of.)
2. Assembled Small Barrel
The plate surface and tube composition are forming, the four screws are fixed, the shaft hole is galvanized iron sleeve, the diameter of the cylinder is 130mm, the weight is about 2.1kg, and the normal can be loaded by 50kg. It is used for copper wires, wires, strangers, and drawing machines. The assembly type is stronger, and the height can also be adjusted. The size of the axis can also be changed according to different needs. It is an integrated enhanced version, but the dynamic balance is slightly weaker.
3. Assembled Big Barrel
The plate surface and tube composition are forming, the 4 screws are fixed, the diameter of the cylinder is 155mm, the weight is about 2.12kg, and it can bear 50kg normally. Only the size of the tube body is different from the assembly type (special wires have higher requirements for bending, and the cylinder can be better protected).
For more line knowledge, please click the link below to learn more.